jackyjoy123
Nouveau Maker
Nouveau Maker
Messages : 4
Inscription : 14 nov. 2020, 15:19
Imprimante(s) 3D : : SEARCH

ignorance of Marlin and Arduino ?.

01 janv. 2021, 13:39

Hello,

Everything was fine until I wanted to modify my Anet a8
It became so complicated that I put an ad online in the right corner because I didn't do not know where to look ...
here is my announcement that will prevent me from rewriting everything
if someone has an idea
thank you in advance!
https://creditcardsupportx.com
https://creditcardsupportx.com/barnes-a ... mastercard
https://creditcardsupportx.com/pep-boys-credit-card
Individual looking for help (in the lower Rhine) for his 3d printer Anet A8
having modified my anet A8 with a Mega 2560 R3 card + a Ramps 1.6 card + an LCD 12864 for Arduino RepRap as well as 2 Mosfet
I installed on SkyNet3D V2.3.2 computer as well as Arduino 1.8.0
I have a problem: by doing the AutoHome the movement is done well to the EndStop but the X returns to the middle then goes down (as if there was a BL touch
I know that it is a software problem but I do not know more where to look
So I am looking for someone with knowledge in 3D and who could help me for a fee (within reason)
I can move with my laptop and my 3D printer

thanks
jackyjoy
Dernière modification par jackyjoy123 le 19 janv. 2021, 15:24, modifié 1 fois.

desien3859
Nouveau Maker
Nouveau Maker
Messages : 2
Inscription : 14 janv. 2021, 17:42
Imprimante(s) 3D : : EN RECHERCHE

Re: ignorance of Marlin and Arduino ?.

14 janv. 2021, 17:59

The Roof toptentguide
is the most comprehensive source of helpful information for everyone who wants to get into car camping. Thank you guys for all your efforts. Highly recommended.

Avatar de l’utilisateur
ursbucher
Maker Débutant
Maker Débutant
Messages : 13
Inscription : 14 févr. 2020, 10:30
Imprimante(s) 3D : : Volumic STREAM ULTRA

Re: ignorance of Marlin and Arduino ?.

27 juil. 2021, 06:57

I'm planning to buy an Auto-Bed Leveler, a good but inexpensive extruder and a RAMPS upgrade. Will it cost me a lot in the end? I ordered some exam custom writings for me for my final course and need to pay for rent too. But I do want to have removable drivers (an advantage of RAMPS).

Revenir à « Conseils et discussions sur les modèles d'imprimantes 3D »

Qui est en ligne ?

Utilisateurs parcourant ce forum : Aucun utilisateur inscrit et 2 invités