MazukFarnas
Nouveau Maker
Nouveau Maker
Messages : 1
Inscription : 14 nov. 2019, 13:20
Imprimante(s) 3D : : HP

Duet 2 wifi switching from v2.2 bl touch to v3.0 bl touch

14 nov. 2019, 13:22

hoping some one can help me. I am using a bl touch probe v2.2 (cut connection to make 3.3v logic) on my duet 2 wifi v1.4 worked fine but broke the plastic probe. ordered a new bl touch v3.0 smart did not change wiring because I was under the impression that it would send 3.3 v instead of 5v is this true? I think it cooked duet 2 wifi as now when trying to use probe I get "Error: Z probe already triggered at start of probing move". If i did cook the pin is there a fix for this? Anyone know what I'm doing wrong between the two versions of the BL touch? any input is appreciated thank youfedloan irs.gov easybib

Avatar de l’utilisateur
ursbucher
Maker Débutant
Maker Débutant
Messages : 15
Inscription : 14 févr. 2020, 10:30
Imprimante(s) 3D : : Volumic STREAM ULTRA

Re: Duet 2 wifi switching from v2.2 bl touch to v3.0 bl touch

05 oct. 2021, 08:53

You don't need a resistor for bl touch 3.0. And the wire might be bad from the manufacturer. Try to use the old one. I did firmware configurations on a Duet 2 Wifi v1.03 and wrote a short guide for engineering students in the research files of the legal custom writing service for Duet3D / DuetSoftwareFramework.

Revenir à « Conseils et discussions sur les modèles d'imprimantes 3D »

Qui est en ligne ?

Utilisateurs parcourant ce forum : Aucun utilisateur inscrit et 2 invités