Unable to run my Prusa I3 on ​​Mac

[iosman123]

Hello,

Complete beginner in 3D printing, I bought a Prusa I3 rework kit that I just finished up.
The problem is that the user manual shows how to connect the printer to a PC but does not speak at all of Mac ...

Despite reading dozens of post on forums French and English, I did not failed to run my printer so far

Would there be a charitable soul living in the Upper Rhine who could help me ??

thanks
iosman

[RandyBonnette]

Hello,

Complete beginner in 3D printing, I bought a Prusa I3 rework kit that I just finished up.
The problem is that the user manual shows how to do my essay and connect the printer to a PC but does not speak at all of Mac ...
Despite reading dozens of post on forums French and English, I did not failed to run my printer so far
Would there be a charitable soul living in the Upper Rhine who could help me ??

thanks
iosman

Hi,

Have you tried to use OctoPi on the Raspberry Pi? In this case the Mac will connect to the RPi over the network, and the RPi will be connected directly to the printer via the USB.
I'm currently using Marlin on my printer with a ramps port. However, I'm looking for the guide how to configure the Melzi board properly.

Randy